Square Metal Watch/
/

Standard flange plate used for mounting accessories for the duct work. plate flanges can be bent to any size, but there are two common types of flanges. The flange is appointed by the leadership that bends in the duct flange.

A flange "in" is, as its name describes, he turned to the inside the ducts and a "flange out" is tilted toward the outside of the ducts. Both types of double flange in the same way, the difference is the way to develop the contours the flange to the designer brands to the ductwork.

Set the type to 1 inch. Run the scribe along the edge of the pipe that will receive the flange. Measure across the plate with the tape measure and use the permanent marker to trace the location of the curves have to be made through the flange sheet metal duct.

Cut a straight line with the aviation snips at each corner location marked in Step 1. The cut should extend the full width of 1 inch the flange of an inch. Notch the corners of the flange required seams side connections of ductwork.

Run the duct through deployment of all old equipment needed to place seam edges on the piece of the ducts before turning the flange of the steel.

Place the sheet metal on the edge of the hand brake sheet metal. Slide so that the flange does not require the parking brake first, with the scribe mark an inch up. Align mark on track 1-inch upper blade clamping brake. Pull down the lock handle on one side of the parking brake. Switch to the other side of the parking brake. Line-up of the scribe mark with this side of the blade clamp and pull the locking lever on that side to completely secure the sheet metal on the parking brake.

Hold the bottom of the sheet bending handbrake handles. Pull the sheet as you watch bending sheet metal. When the flange is about 90 degrees lower blade bending and release the sheet metal by increasing the blade clamp brake handles.

Pull the metal plate in front of the subject sheet 4 inches. Check the sheet metal flange 90 degrees with the combination square. If the leaf base and the combination square, both rest completely on the metal plate and the flange, the curve is 90 degrees. If the curve is 90 degrees, push the metal plate in place, hold the metal back into the parking brake, and lift the top sheet bending to adjust the curve of the flange sheet.

Verification flange plate for square using the method described in Step 6. If the flange is still short of 90 degrees, repeat the process of attachment and bending to tighten the flange. Use the hammer to open the clamp if you go over 90 degrees. Views of the light metal flange with the mallet. Views throughout the flange with the mallet. The set closer struck the wing, even more will flange.

Doubling the width and height of the ducts. Mount the pipe flange plate be placed at the end of the duct length.

hongfengflange.com is the leading manufactory and exporter of steel flange in Zhejiang Province of China.We are specialized in manufacturing and exporting Forged Steel Flange and Pipe Fittings.Welcome to contact and visit for business.

/
//
/Mario Kart Wii Texture Hacks: Metal Rainbow Square: Voice Chat Edition
/
//
//
//
//
/
/
//
//
/
/
/ /
/[affmage source=”ebay” results=”25″]Square Metal Watch[/affmage]/
/[affmage source=”amazon” results=”6″]Square Metal Watch[/affmage]/
/[affmage source=”clickbank” results=”4″]Square Metal Watch[/affmage]/
/

Filed under: Uncategorized

Like this post? Subscribe to my RSS feed and get loads more!